Product ID:68, POLYURETHANE VARNISH STAIN
MSDS Date:11/01/1985
FSC:8010
NIIN:00N032818
MSDS Number: BNSWB

Emergency Phone: 914-699-3311

Info Phone: 914-699-3311

Cage: REDDE

Telephone: (914) 699-3311

Cage: REDDE

MINERAL SPIRITS

CAS: 64742-88-7

Fraction By Weight: 62.9%

OSHA PEL 500 PPM (MFR)

ACGIH TLV: 100 PPM (MFR)

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES; CAN CAUSE SEVERE IRRITATION,
REDNESS, TEARING, BLURRED VISION. SKIN: PROLONGED OR REPEATED
CONTACT CAN CAUSE MODERATE IRRITATION, DEFATTING DERMATITIS.
INHALATION: EXCESSIVE INHALATION OF VAPORS CAN CAUSE NASAL AND
RESPIRATORY IRRITATION, DIZZINESS, WEAKNESS, FATIGUE, NAUSEA,
HEADACHE, POSSIBLE (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ: UNCONSCIOUSNESS, AND EVEN
ASPHYXIATION. INGESTION: CAN CAUSE GASTROINTESTINAL IRRITATION,
NAUSEA, VOMITING AND DIARRHEA. ASPIRATION OF MATERIAL INTO LUNGS
CAN CAUSE CHEMICAL PNEUMONITIS WHIC H CAN BE FATAL.
Medical Cond Aggravated by Exposure:ACUTE AND CHRONIC RESPIRATORY
DISORDERS, SKIN AND CERTAIN EYE DISORDERS, LIVER AND KIDNEY
DISORDERS.

First Aid:SKIN:THORO WASH EXPOS AREA W/SOAP & H2O. REMOVE CONTAM CLTHG.
LAUNDER CONTAM CLTHG BEFORE RE-USE. EYES:FLUSH W/LRG AMTS OF H2O
FOR AT LEAST 15 MIN,LIFTING UPPER & LOWER LIDS OCCAS,GET MED
ATTN.INGEST: DO NOT INDUCE VOMIT, KEEP PERSON WARM,QUIET & GET MED
ATTN. ASPIR OF MATL INTO LUNGS DUE TO VOMIT CAN CAUSE CHEM PNEUM
WHICH CAN BE FATAL. INHAL:REMOVE INDIV TO FRESH AIR.IF BRTHG IS
DFCLT, (SUPDA

Flash Point:100F,38C
Extinguishing Media:FOAM, CO2, DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT
EQUIP.H2O MAY BE USED TO COOL CLSD CNTNRS TO PVNT PRESS BUILDUP &
POSS AUTOIGNIT/EXPLO WHEN EXPOS TO EXTREME HEAT
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED, ISOLATE
FROM HEAT AND OPEN FLAME. CLOSED CONTAINERS MAY EXPLODE WHEN
EXPOSED TO HIGH HEAT.

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE
AREAS. REMOVE WITH INERTS AND OR ABSORBENTS, (VERMICULITE, DRY
SAND, EARTH, ETC.) USE NON SPARKING TOOLS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:CONTAINERS SHOULD BE PROPERLY GROUNDED
WHEN POURING TO PREVENT STATIC BUILDUP. KEEP CONTAINERS COOL AND
DRY AND AWAY FROM HEAT, SPARKS & OPEN FLAME.
Other Precautions:DO NOT BREATH SPRAY MIST. USE AND STORE THIS PRODUCT
WITH ADEQUATE VENTILATION. AVOID SPONTANEOUS COMBUSTION OF
CONTAMINATED RAGS OR OTHER EASILY IGNITABLE ORGANIC ACCUMULATIONS
BY IMMERSION IN WATER.

Respiratory Protection:USE W/ADEQ VENT. IN RESTRICTED VENTILATION AREAS
USE NIOSH/MSHA APPROVED CHEMICAL/MECHANICAL FILTERS DESIGNED TO
REMOVE COMBINATION OF PARTICULATES AND VAPOR. IN CONFINED
VENTILATION AREAS USE NIOSH/M SHA APPRVD AIR LINE TYPE RESP/HOODS.
Ventilation:GEN MECH VENT DESIGNED & MAINTAINED TO PROVIDE SUFF VENT,IN
VOL & PATTERN TO KEEP AIR CONTAM CONC BELOW CURRENT (SUPDAT)
Protective Gloves:NEOPRENE GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:USE PROT APRONS. AVAIL OF EYE WASH & SAFETY
SHOWER STATIONS IS HIGHLY RECOM. USE PROT CREAM (NON SOLV SOLUBLE)
(SUPDAT)
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING/USING
WASHROOM. SMOKE IN SMOKING AREAS ONLY.REMOVE & WASH CONTAM CLTHG
BEFORE (SUPDAT)
Supplemental Safety and Health
FIRST AID PROC: ADMIN OXYGEN. IF BRTHG HAS STOPPED GIVE ARTIFICIAL
RESPIRATION. KEEP PERSON WARM, QUIET & GET MED ATTENTION. VENT:
OSHA PERMISSIBLE EXPOS LIMIT/ACGIH'S TLV LIMIT. OTHER PROT EQUIP:
WHE RE SKIN CONTACT IS LIKELY. HYGIENE PRACT: RE-USE. DISCARD
CONTAMINATED SHOES.

HCC:F4
Boiling Pt:B.P. Text:300F,149C
Vapor Pres:2.00
Vapor Density:HVR/AIR
Spec Gravity:0.8781
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:70.43

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, STRONG ACIDS, BASES AND CERTAIN AMINES.
Stability Condition to Avoid:HIGH TEMPERATURES.
Hazardous Decomposition Products:CAN FORM TOXIC MATERIALS WHEN BURNED:
CO, CO2 AND VARIOUS HYDROCARBONS ETC.

Waste Disposal Methods:INCINERATE UNDER SAFE CONDITIONS OR DISPOSE OF
IN AN APPROVED LANDFILL, IN ACCORDANCE WITH LOCAL, STATE AND
FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.